Charnwood W616 Instruções de Operação descarregar pdf (Página 13)

Troubleshooting

Saw vibrates

Check all nuts and bolts for tightness, check

tilt is locked and check that blade is not

damaged.

Cuts are slow, wood is blackened

Examine the blade. If any carbon tips are

missing or broken the blade should be

replaced. If the tips are blunt, the saw blade

may be professionally sharpened.

Saw stalls

Feed rate too high, slow down.

Tilt and/or blade height difficult to adjust

Rip fence is not parallel to blade

Lower saw guard fills with dust

Motor is running, but blade stationary

When pressing start, nothing happens

Check tilt lock has been released, clean and

lubricate mechanism.

Bring the fence to a straight line on the table

top. Use a Hex key to undo the 2 adjusting

screws, located in the blue painted section,

and re-align the fence so it is parallel.

It is essential to use a vacuum extractor or

chip collector with this machine. If one is

being used, check for blockages in the hose.

Check the drive belt, replace if broken

Check fuse, check switch, Check carbon

brushes & replace if worn

Declaration of Conformity for CE Marking

Charnwood Declare that Woodworking Circular Saw, Model W616

Conforms with the following Directives: Machinery Directive 2006/42/EC

Low Voltage Directive 2006/95/EC

EMC Directive 2004/108/EC

And further conforms to the machinery example for which the EC type examination

Certificate No. BM 50166724, AN 50166720 and AE 50243515 have been issued by

TUV Rheinland LGA Products GmbH, Tillystrasse 2, 90431, Nurnberg.

I hereby declare that equipment named above has been tested and found to comply

with the relevant sections of the above referenced specifications. The machinery

complies with all essential requirements of the directive.

Signed: Dated: 26/11/2009 Location: Leicestershire

Richard Cook, Director

1 2 ... 8 9 10 11 12 13 14 15 16

Sem comentários

Charnwood W616 Instruções de Operação Página 13