Charnwood W625 Manual do Proprietário

TABLE SAW OPERATORS MANUAL MODEL: W625 Charnwood, Cedar Court, Walker Road, Hilltop Industrial Estate, Bardon Hill, Leic

Optional Sliding Carriage Note: If installed, remove the mitre fence guiderail which is bolted to the left hand side of the table. Unpack the

Setting The Sliding Table Firstly set the height: These holes are slotted so that the carrier may be adjusted up or down to bring the sliding car

There is an adjustable, flip-over length stop on the fence, to speed up repetitive work. Use a set square to set the mitre fence e

Cutting Depth Adjustments to the cutting depth should be made only when the saw is not running. Turn the crank handle to set the blade to the require

The saw is supplied with 2 spanners. Use the peg spanner to lock into the saw blade flange and hold the blade stationary. Use the 13mm spanner to un

Charnwood W625 Exploded Diagram

W625 Parts List Item Part QTY Item Part QTY 01 Table 1 55 Motor, Induction 240v, 1600w 1 02 Leg 4 56 NVR switch 1 03 Rail - long 2 57 Depth of cut adj

Charnwood W625SC Exploded Diagram - Sliding Carriage Assembly W625SC Parts List Item P

GENERAL SAFETY RULES WARNING: Do not attempt to operate the machine until you have read thoroughly and understood completely all instructions, rules

16. Disconnect the machine from power source before servicing and when changing the blade. 17. Never leave the machine running unattended. Turn the

Specification Table size 550(w) x 1600(d)mm Table size with optional table extension Table height 950(w) x 1600(d)mm 800mm Motor (carbon brush)

Unpacking This saw is best unpacked on the floor as it is quite heavy. Open the carton, carefully unpack all of the contents and lift the body of

Bolt the four rails together as shown, using three M6 x 16mm bolts with washers and nuts in each corner. It does not matter which pair, the long o

Offer up the NVR switch and fix it in place with the two self tapping screws provided. Bolt on the dust extractor port noting that the s

Fit one end of the dust collection hose to the spigot on the back of the crown guard, fit the other end to the side inlet of the dust extractor po

Rip fence Mitre fence Optional Side Extension Table If you have purchased the optional right hand extension table; Bolt the two support br